top of page

Keypad Instructions & Faults

DAS/Hills Alarm Panel

To Arm System

Enter USER CODE the # (Away) eg. 1 2 3 4 # (Away)

AWAY light comes ON

To Disarm System

Enter USER CODE then # (Away) eg. 1 2 3 4 # (Away)

Away light comes OFF

Memory Recall

Enter MASTER CODE then 3 then # (Away) eg. 1 2 3 4 3 # (Away)

Event is displyed – most recent displayed 1st to the least recent

For further instructions please download the Bosch Alarm Panel Operators Manuals

Isolate Sectors (Permission Required)

Enter * twice, USER CODE then ZONE then * (Stay)

Repeat for other zones to isolate, then # to exit feature

eg to isolate ZONE 2: ** 1 2 3 4 02 * # (Away)

​

Fault Reports

Press and HOLD number 5 until 2 beeps are heard

Zone light indicates FAULT condition

Refer to chart below and once fault is identified, enter # to exit this feature

Fault Chart Analysis

Zone 1 – Battery low

Zone 2 – Date/Time reset

Zone 3 – Sensor watch fail

Zone 4 – Horn speaker fail

Zone 5 – Telephone line fail

Zone 6 – EPROM fail

Zone 7 – Fuse fail

Zone 8 – Communication fail

Other System Tests

TEST REPORT – Press 9 on keypad until you hear two beeps

SIREN – Press 1 and hold until you hear two beeps – siren will sound for 2 seconds

BELL – Press 2 until you hear two beeps – pieza will sound for 2 seconds

STROBE – Press 3 until you hear three beeps – this will turn stobe ON. Repeat, press 3 until you hear three beeps to turn stobe off.

Reset Time & Date

Enter MASTER CODE then 6 then # (Away) eg. 1 2 3 4 6 # (Away)

Enter the current – day (DD), Month (MM), Year (YY), Hour (HH), Minute (MM)

(EG 15th Nov 2007 at 15:20 hrs = 1 5 1 1 0 7 1 5 2 0 # (Away)

Panel Sounders

BEEPING SOUND – If plug pack is unplugged or the mains POWER is disconnected the keypad will SOUND once very minute. To silence, press 5 and hold until you hear two beeps to display fault, see fault list and instructions above then press # to exit this feature.

bottom of page